![]() The nearest outside surface of the cable must be located no less than 1.25 in. Despite its protective element, AC cable installed through or parallel to framing members must be protected against penetration by screws or nails per 300.4 and 320.17. Ceiling paddle fans exceeding 35 lb must be supported independent of the outlet box, unless the box is listed to support the weight of the ceiling fan. Typically, an outlet box identified for this purpose may be used to support only ceiling paddle fans that weigh as much as 35 lb. ![]() Where a box is used as the sole support for a ceiling paddle fan, the box must be listed for this purpose and be able to support the weight of the fan. Luminaires that weigh more than 50 lb must be supported independent of the outlet box, unless the box is listed for the luminaire's weight. Per 314.27(B), outlet boxes may be used to support luminaires that weigh as much as 50 lb. An exception to 314.27(A) was revised to clarify that wall-mounted fixtures may be supported by device boxes or device plaster rings with no fewer than two No. You're now required to mount and mechanically secure an extension ring over the flush box when installing a surface extension on a flush-mounted box. A change to 314.22 clarifies the requirements for the installation of exposed surface extensions. You must size Type SE service-entrance cable used for interior wiring based on the 60☌ conductor ampacity limitations listed in 334.80. You may install NM cable as an open run in dropped or suspended ceilings in other than one- and two-family and multifamily dwellings. You may install nonmetallic-sheathed cable in multifamily buildings of Types III, IV, and V construction above three stories, except as prohibited in 334.12. Outlet boxes may be used to support luminaires that weigh as much as _ lb.Ĭeiling fans weighing no more than _ lb may be supported by an outlet box identified for this purpose.ĪC cable installed through or parallel to framing members needs not be protected from penetration by screws or nails. The Code requires you to mount an extension ring over a flush box when installing a surface extension on a flush-mounted box.Ī _ mounted luminaire weighing no more than 6 lb may be supported by device boxes or plaster rings that are secured to other boxes, provided the luminaire is secured to the box with no less than two No.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |